Yeoman Rainguard have been shortlisted for best rainwater goods supplier Homebuilding & Renovating award.

We are now fully operational at our Head Office and factory in Leeds following a period of shutdown having implemented all safety measures and government guidance to enable us to do so. Click here to see confirmation of our COVID-19 Secure Status

Please call us on 0113 279 5854 or email with any enquiries for materials and/or installation you have – we are here to help.

Should you wish to place an order then simply email and our internal sales team will do the rest.

May we take this opportunity to pay tribute to all key workers who have helped and continue to help keep us safe and keep the country running through this unprecedented crisis. Thank You.

Close Popup

GRP Installation Instructions

GRP Gutters

  1. Fix gutter brackets to give correct line and level (min. 2 no. brackets per length). Ensure fixings are adequate to obviate pull out.
  2. Place gutter in position ensuring correct sit into brackets.
  3. At joint, drill gutters through underside and also through top of front face to accept gutter bolts (holes to be 3mm oversize to allow for thermal movement).
  4. Ensure gutter socket and spigots are dry, clean, dust and grease free prior to applying silicone sealant.
  5. Apply 2 no. 6mm sealant beads between spigot and socket joint around bolt hole to ensure alignment of leading edges of gutter when joints are bolted together.
  6. Bolt joints together through previously drilled holes, at the same time aligning front edges. Do not over tighten.
  7. Drill back of gutter approx. 18mm from top at every joint and maximum 600mm centres. (Holes to be 3mm oversize to allow thermal movement).
  8. Secure gutter through previously drilled holes in back, using a minimum 18mm OD washer between head of fixing and gutter. Do not over tighten and cause misalignment of gutter (use packers between back of gutter and wall if necessary). Ensure fixings are adequate to obviate pull out.
  9. Secure gutter to bracket by bolting through hole provided at every alternate bracket.
  10. Remove any surplus sealant from faces of gutter. The Yeoman Rainguard GRP guttering should be fixed wherever possible using the profile gutter brackets. This principle applies even when existing corbels are used. Where it is not possible to use brackets and the gutter is sat only on corbels, the gutters can be manufactured with extra strengthening, however the corbels should project far enough to support the full underside of the gutter.

GRP Installation Guide

Download Installation Guide

GRP Pipes

Drill hole through ears of pipe using HSS drill.

Place rainwater pipe in correct position and mark wall through pre-drilled holes in ears of pipe.

Drill wall using appropriate masonry bit.

Use only stainless steel screws and place through washer provided.

Fix through pre-drilled pipe ears using appropriate length screws and plugs to obviate pull out.

When fixed securely push on a seal cover to conceal screw head.

Ensure pipes are plumb and offer up next pipe or component.

Fit in to socket leaving approx. 5mm gap for expansion and contraction.

Joints between sections can be pointed with silicone if required.

Bobbins are available to ensure a straight line to rainwater pipes where the building surface may be uneven.

Pipes may be cut to length using a fine tooth hacksaw.

XL Aluminium Guide



Take a closer look at our full product range...

Privacy Policy